ESNAP settings in status bar

Topics related to ActCAD 2D Commands
Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

ESNAP settings in status bar

Postby Sriharan » Sat Jun 24, 2017 4:14 am

How we will do ESNAP settings in status bar?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: ESNAP settings in status bar

Postby Sriharan » Sat Jun 24, 2017 4:15 am

You can set entity snaps using any of the following methods:

• On the ribbon, choose Draw 2D and in Entity Snaps, choose the entity snap you want to set.

• Choose Tools > Entity Snap, and choose the entity snap you want to set.

• On the Entity Snaps toolbar, click one of the entity snap tools.

• In the command bar, type an entity snap command.

• In the status bar, double-click ESNAP.

• Press and hold down the Shift key while right-clicking anywhere within the draw­ing window to display the entity snap shortcut menu, and then choose the entity snap you want to set.

You can also set entity snaps using the Drawing Settings dialog box. To do this, choose Tools > Entity Snap > Entity Snap Settings. The Drawing Settings dialog box is displayed with the Coordinate Input tab active. In the Entity Snap Modes list, click the check box for each of the entity snaps that you want to set.


Return to “ActCAD 2D Commands”

Who is online

Users browsing this forum: No registered users and 1 guest