Elliptical Arc

General Topics related to ActCAD Software
Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Elliptical Arc

Postby Sriharan » Sat Jun 24, 2017 6:37 am

I want to draw an ellipse by specifying the endpoints in ActCAD software?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Elliptical Arc

Postby Sriharan » Sat Jun 24, 2017 6:39 am

To draw an ellipse by specifying the endpoints

a. Specify the start point on the major axis.
b. Specify the endpoint of the major axis.
c. Specify the half length of the minor axis.
d. Specify the endpoint of the ellipse axis.

Second end of axis: Specify the second endpoint.

Rotation · <Other axis>: Specify the other axis to draw the ellipse dynamically. To specify the rotation, choose Rotation and specify the angle of rotation.


Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 2 guests