## Edit Polyline

### Edit Polyline

I have an issue in a polyline.I draw a polyline now we want to edit vertex is it possible in ActCAD software?

### Re: Edit Polyline

To edit a vertex

Choose Edit vertices.

Edit vertices: Next · Previous · Angle · Break · Insert · Move · Regen · SElect · Straighten · Width · eXit · <Next>: The first vertex (start point) of the polyline is marked with a triangle and an x. If this is not the vertex you want to edit, choose Next; the x marker moves to the next vertex. To select the previous vertex, choose Previous. To change the angle of the current vertex, choose Angle. To break the polyline at this vertex, choose Break. To insert a segment after this vertex, choose Insert. To move this vertex, choose Move. To regenerate the polyline, choose Regen. To select a vertex by specifying a polyline segment, choose SElect. To straighten a vertex, choose Straighten. To change the width of an individual segment, choose Width.

Choose Edit vertices.

Edit vertices: Next · Previous · Angle · Break · Insert · Move · Regen · SElect · Straighten · Width · eXit · <Next>: The first vertex (start point) of the polyline is marked with a triangle and an x. If this is not the vertex you want to edit, choose Next; the x marker moves to the next vertex. To select the previous vertex, choose Previous. To change the angle of the current vertex, choose Angle. To break the polyline at this vertex, choose Break. To insert a segment after this vertex, choose Insert. To move this vertex, choose Move. To regenerate the polyline, choose Regen. To select a vertex by specifying a polyline segment, choose SElect. To straighten a vertex, choose Straighten. To change the width of an individual segment, choose Width.

### Re: Edit Polyline

How can we change the angle of the selected vertex?

### Re: Edit Polyline

Choose Angle.

Included angle for vertex segment (<0 is cw, 0 is straight, >0 is ccw) <0º>: Enter the angle for the segment. To angle the vertex in a clockwise direction, enter a value less than zero. To angle the vertex in a counterclockwise direction, enter a value greater than zero.

Included angle for vertex segment (<0 is cw, 0 is straight, >0 is ccw) <0º>: Enter the angle for the segment. To angle the vertex in a clockwise direction, enter a value less than zero. To angle the vertex in a counterclockwise direction, enter a value greater than zero.

### Re: Edit Polyline

How to insert a new vertex??????

### Re: Edit Polyline

To insert a new vertex

Choose Insert.

Location for new vertex: Specify the location of the new vertex.

Choose Insert.

Location for new vertex: Specify the location of the new vertex.

### Who is online

Users browsing this forum: No registered users and 1 guest