Fit tolerance

General Topics related to ActCAD Software
Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Fit tolerance

Postby Sriharan » Mon Jun 26, 2017 5:34 am

How to specify the fit tolerance?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Fit tolerance

Postby Sriharan » Mon Jun 26, 2017 5:35 am

To specify the fit tolerance
1 Do one of the following to choose Spline ( ):
• On the ribbon, choose Draw > Spline.
• On the menu, choose Draw > Spline.
• On the Draw toolbar, click the Spline tool.
• Type spline and then press Enter.
2 Specify the first point of the spline.
3 Specify the second point of the spline.
4 In the prompt box, choose Fit Tolerance.
5 To accept the default of 0.0000, press Enter.
To specify a different fit tolerance, type the number, and then press Enter.
6 Specify the additional points you need to draw a spline or a closed spline.


Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 2 guests