Calibrating the tablet

General Topics related to ActCAD Software
Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Calibrating the tablet

Postby Sriharan » Fri Jun 30, 2017 4:19 am

How to calibrate your tablet for digitizing points?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Calibrating the tablet

Postby Sriharan » Fri Jun 30, 2017 4:20 am

1 Do one of the following:
• Choose Tools > Tablet > Calibrate.
• Type tablet, choose Calibrate, and then press Enter.
2 Click a point on the tablet to define as the first calibration point.
3 Specify a point within the IntelliCAD drawing window to correspond to the point
you digitized on the tablet, or enter coordinate values in the command bar.
4 Click a point on the tablet to define as the second calibration point.
Specify a point within the IntelliCAD drawing window to correspond to the point
you digitized on the tablet, or enter coordinate values in the command bar. To
specify more than the two points required, click a point on the tablet to define as
the third calibration point. You can enter up to 10 points.
5 Choose the transformation type, and then press Enter.


Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 1 guest