Line by first specifying the length

General Topics related to ActCAD Software
Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Line by first specifying the length

Postby Sriharan » Fri Jun 30, 2017 7:40 am

How to draw a line by first specifying the length?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Line by first specifying the length

Postby Sriharan » Fri Jun 30, 2017 7:40 am

Choose Length.

Length of line: Enter the length of the line.

Angle of line: Specify the angle of the line, or enter the angle (in degrees).

Angle · Length · Follow · Undo · <End point>: To continue drawing line segments (the start point of each line segment is the endpoint of the previous segment), specify the next endpoint. To specify the length of the next line segment, choose Length.


Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 1 guest