Join multiple edges

General Topics related to ActCAD Software
Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Join multiple edges

Postby Sriharan » Fri Jun 30, 2017 7:46 am

How to join multiple edges to create a cross section while lofting?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Join multiple edges

Postby Sriharan » Fri Jun 30, 2017 7:47 am

Select cross sections in lofting order or [Point/Join multiple edges/Mode]: Choose to Join multiple edges.

Select edges that are to be joined into a single cross section: Select the edges, which must share start and end points, to be considered as a cross-section. When done selecting edges, press Enter.

Continue creating the loft entity using the prompts described above.


Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 2 guests