Copy and Paste does not work

General Topics related to ActCAD Software
Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Copy and Paste does not work

Postby Sriharan » Fri Jun 23, 2017 7:57 am

Copy and Paste does not work. I can not copy the drawing in another drawing ?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Copy and Paste does not work

Postby Sriharan » Fri Jun 23, 2017 7:58 am

The reason could be that the drawing from which entities are being copied was closed. -- Make sure the file from which the entities were copied is still open. -- If it proves closed: open the file of the drawing of origin, select entities to be copied from the Edit menu and choose "Copy" or "Copy with Base Point." -- Open or move into the drawing of destination without closing the drawing of origin, Edit menu and choose Paste "or" Paste to Original Coordinate". NOTE: The right way to copy is always use the command "Copy" from the Edit menu.


Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 1 guest