Wedge drawing in 3D Mesh

Topics related to ActCAD 3D commands and Features
Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Wedge drawing in 3D Mesh

Postby Sriharan » Sat Jun 24, 2017 9:29 am

How we can draw wedge(3D Mesh)???

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Wedge drawing in 3D Mesh

Postby Sriharan » Sat Jun 24, 2017 9:30 am

Toolbar: Draw 3D Meshes > Wedge

Ribbon: Draw 3D > Wedge (in Draw 3D Meshes)

Menu: Draw > 3D Meshes > Wedge

Keyboard: AI_WEDGE, and WEDGE for versions without ACIS support

Alias: WE (for versions without ACIS support)

Experience Level: Intermediate

Draws a three-dimensional wedge as a 3D mesh.

Specify the first corner of the wedge.
Specify the opposite corner of the wedge.
Specify the height of the wedge.

Center · <Corner of wedge> <0.0000,0.0000,0.0000>: To specify the first corner of the wedge, specify a point or enter the x,y,z-coordinates.

Cube · Length · <Opposite corner>: To dynamically draw the base of the wedge, the default setting, specify the opposite corner. To draw a cube, choose Cube. To specify the three dimensions of the wedge (length, width, height), choose Length.

Height of wedge: Specify a point or enter the height in drawing units.

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Wedge drawing in 3D Mesh

Postby Sriharan » Sat Jun 24, 2017 9:31 am

How to draw a cubic wedge?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Wedge drawing in 3D Mesh

Postby Sriharan » Sat Jun 24, 2017 9:32 am

Specify the first corner of the wedge.
Specify the length of the sides of the wedge.

Choose Cube.

Length of sides of cubic wedge: Specify two points, or enter the length in drawing units. The wedge is drawn with equal length, width, and height measurements.

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Wedge drawing in 3D Mesh

Postby Sriharan » Sat Jun 24, 2017 9:32 am

How to specify the length of wedge?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Wedge drawing in 3D Mesh

Postby Sriharan » Sat Jun 24, 2017 9:33 am

Specify the first corner of the wedge.
Specify the length.
Specify the width.
Specify the height.

Choose Length.

Length of side: Specify two points, or enter the length in drawing units.

Width of wedge: Specify two points, or enter the length in drawing units.

Height of wedge: Specify two points, or enter the length in drawing units.


Return to “ActCAD 3D Commands”

Who is online

Users browsing this forum: No registered users and 0 guests