Non-rectangular viewport

General Topics related to ActCAD Software
Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Non-rectangular viewport

Postby Sriharan » Sat Jun 24, 2017 9:55 am

Is it possible to create a non-rectangular viewport in ActCAD software?

Sriharan
Posts: 309
Joined: Wed Jun 21, 2017 6:53 am

Re: Non-rectangular viewport

Postby Sriharan » Sat Jun 24, 2017 9:56 am

Choose Polygonal.

Start of polyline: Select the start point of the polyline you want to use for the non-rectangular viewport.

Arc/Distance/Follow/Halfwidth/Width/Undo/<Next point>: Select the next point of the polyline. To draw an arc as a polyline segment, choose Arc. To specify the length of the next polyline segment, choose Distance. To continue the polyline in the direction of the last entity you drew, choose Follow. To specify the halfwidth of the following polyline segments, choose Halfwidth. To specify the width of the following polyline segments, choose Width.

Continue to draw polyline segments by selecting points or options in the command bar. When you are finished, right-click or press Enter to close the polyline and end the command.


Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 1 guest